Diseño y fabricación de máquina de ensayo para desgaste tipo pin-disco abrasivo

Fecha

2013-07-20

Autores

Barreto León, Yuniesky

Título de la revista

ISSN de la revista

Título del volumen

Editor

Universidad Central "Marta Abreu" de Las Villas

Resumen

En el presente trabajo se abordó el proceso de fabricación de una máquina para la realización de ensayos de desgaste abrasivo tipo espiga disco abrasivo. Para la realización del mismo se siguieron las orientaciones de la norma ASTM G 132, que establece los parámetros fundamentales para la realización de varias máquinas para el ensayo de desgaste abrasivo entre las que se encuentra la que se trata en esta tesis. También se hace un análisis de lo estipulado en dicha norma para la realización del ensayo y el tratamiento posterior de los resultados. Finalmente se desarrollan las tecnologías de fabricación de las piezas que no están normalizadas y que fue necesario fabricar para la construcción de la máquina.
In the present work was approached the process of production of a machine for the wear abrasive tests type pin-abrasive disk. For the realization of the same one it was followed the orientations of the standard ASTM G 132 that it establishes the fundamental parameters for the realization of several machines for the rehearsal of wear abrasive among those that its is the one that is in this thesis. An analysis is also made of that specified in this norm for the realization of the rehearsal and the later treatment of the results. Finally the technologies of production of the pieces are developed that are not normalized and that it was necessary to manufacture for the construction of the machine.

Descripción

Palabras clave

Diseño, Fabricación, Máquina de Ensayo, Desgaste, Pin-disco Abrasivo

Citación